Brother DCP-9040CN - Page 104

Network Scanning
97
4
Note
If you want to scan a document using the duplex scanning feature, you need to put the document in the
ADF and then choose 2sided (L)edge or 2sided (S)edge depending on your document layout.
e Press a or b to choose your E-mail Server.
Press OK.
Go to Step f if you have set up only one E-mail server.
f Press a or b to choose Change Setting. Press OK. If you don’t have to change the quality, press a
or b to choose Enter Address. Press OK and then go to Step j.
g Press a or b to choose Color 150 dpi, Color 300 dpi, Color 600 dpi, B&W 200 dpi or
B&W 200x100 dpi. Press OK.
If you choose Color 150 dpi, Color 300 dpi, Color 600 dpi, go to Step h.
If you choose B&W 200 dpi or B&W 200x100 dpi, go to Step i.
h Press a or b to choose PDF or JPEG. Press OK and go to Step j.
i Press a or b to choose PDF or TIFF. Press OK and go to Step j.
j The LCD prompts you to enter an address. Enter the destination E-mail address from the dial pad or use
the One-Touch key or Speed Dial number. Press Black Start or Color Start. The machine starts the
scanning process.
Using One-Touch or Speed-Dial number 4
You can also scan a document directly to an address you registered in a One-Touch or Speed-Dial number.
When you scan the document, the settings you registered with the One-Touch or Speed-Dial will be used for
the quality and the file type. Only One-Touch or Speed Dials with an E-mail address registered can be used
when you scan data using One-Touch or Speed-Dial. (I-fax addresses are not available for use.)
a Put the document face up in the ADF, or face down on the scanner glass.
b Press (Scan).
c Choose One-Touch or Speed-Dial number.
d Press Black Start or Color Start. The machine starts the scanning process.
Note
• Scan type depends on the settings on the Device Button tab, Black Start or Color Start do not change
the settings.
• You can store the scan resolution (Scan Profile) for each E-mail address if you store the E-mail address
in a One-Touch or Speed-Dial number. (See Dialling and storing numbers in Chapter 8 of the User’s
Guide.)