Chapter 3
6
Enlarging or reducing copies 3
You can choose an enlargement or reduction
ratio. If you choose Fit to Page, your
machine will adjust to the size you set in
Paper Size.
a Load your document.
b Press (Copy).
c Enter the number of copies you want.
d Press Options.
e Press s or t on the Touchpanel to
display Enlarge/Reduce.
f Press Enlarge/Reduce.
g Press s or t to display the available
options, and then press the option you
want to change.
h Do one of the following:
If you chose Enlarge or Reduce,
press the enlargement or reduction
ratio you want to use.
If you chose Custom(25-400%),
enter an enlargement or reduction
ratio from 25% to 400%.
Press OK.
If you chose 100% or Fit to Page,
go to step i.
i Press s or t to review and confirm the
displayed list of settings for this copy.
If you do not want to change additional
settings, press OK.
j Press Mono Start or Colour Start.
k Press .
• Page Layout is not available with
Enlarge/Reduce.
• Page Layout, Sort and
Remove Background are not available
with Fit to Page .
• Fit to Page does not work correctly
when the document on the scanner glass
is skewed by more than three degrees.
Using the document guidelines on the left
and top, place your document in the
upper-left corner, with the document face
down on the scanner glass.
198% 10 x15cmiA4
186% 10 x15cmiLTR
141% A5 iA4
100%
97% LTR iA4
93% A4 iLTR
83%
69% A4 iA5
47% A4 i10x15cm
Fit to Page
Custom(25-400%)
To Next Page
Loading...
