Brother DCP-J172W

Chapter 3
10
i If you do not want to change additional
settings, press Mono Start or
Colour Start.
j After the machine scans the page, press
Yes to scan the next page.
k Place the next page on the scanner
glass. Press OK to scan the page.
Repeat steps j and k until all the
pages have been scanned.
l Press No to finish scanning.
The machine starts printing.
m Press .
NOTE
Fit to Page and Page Layout are
not available with Sort.
Adjusting Density 3
You can adjust the copy density to make
copies darker or lighter.
a Load your document.
b Press (Copy).
c Enter the number of copies you want.
d Press Options.
e Press s or t on the Touchpanel to
display Density.
f Press Density.
g Press d or c to make a lighter or darker
copy.
Press
OK
.
h If you do not want to change additional
settings, press OK, and then press
Mono Start or Colour Start.
i Press .
Remove Background Colour 3
Removes the background colour of the
document when copying. This may make the
copy more readable and will save some ink.
NOTE
This function is for use only when making
colour copies. The background colour is
automatically removed for all
monochrome copies.
a Load your document.
b Press (Copy).
c Enter the number of copies you want.
d Press Options.
e Press s or t on the Touchpanel to
display Advanced Settings.
f Press Advanced Settings.
g Press Remove Background.
h Press s or t to display Low, Medium or
High.
i Press Low, Medium or High.
j Press OK.
k Press Colour Start.
l Press .
NOTE
Fit to Page and Page Layout are
not available with Remove Background.