Brother DCP-J172W

Troubleshooting
61
B
Machine Information B
Checking the serial number B
You can see the machine’s serial number on
the Touchscreen.
a Press (Settings).
b Press s or t on the Touchpanel to
display Machine Info.
c Press Machine Info.
d Press Serial No.
e Press .
Checking the firmware
version B
You can see the machine’s firmware version
on the Touchscreen.
a Press (Settings).
b Press s or t on the Touchpanel to
display Machine Info.
c Press Machine Info.
d Press Version.
e Press .
Reset functions B
The following reset functions are available:
1 Machine Reset
You can reset all the machine’s settings
that you have changed, such as the Date
and Time.
2 Network
You can reset the print server back to its
factory settings, such as the password
and IP address information.
3 All Settings
You can restore all settings to their factory
defaults.
Brother strongly recommends performing
this procedure before handing over or
disposing of the machine.
How to reset the machine B
a Press (Settings).
b Press s or t on the Touchpanel to
display Initial Setup.
c Press Initial Setup.
d Press s or t to display Reset.
e Press Reset.
f Press s or t to display the type of reset
(Machine Reset, Network or
All Settings) you want to do, and
then press it.
g Press Yes to confirm.
h Press Yes for 2 seconds to reboot the
machine.