Brother DCP-T220

Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Photo Paper in the Paper
Tray
Load Photo Paper in the Paper Tray
• Load only one size and type of paper in the paper tray at a time.
• When you load a different paper size in the tray, you must change the paper size setting on your computer.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2
1
2. Pull the paper tray completely out of the machine.
3. Lift the output paper tray cover (1).
1
4. Gently press and slide the paper width guides (1) to fit the paper size, and then lift the stopper (2).
1
2
5. Close the output paper tray cover.
23