IMPORTANT
• DO NOT load more than one sheet of paper in the manual feed slot at any time. Doing this may
cause a paper jam. When printing multiple pages, do not load the next sheet of paper until both the
Power LED and the Warning LED are lit.
• DO NOT load paper in the manual feed slot when you are printing from the paper tray. Doing this may
cause a paper jam.
5. Using both hands, push one sheet of paper into the manual feed slot until the front edge touches the paper
feed rollers. Release the paper when you feel the machine pull it. The Power LED blinks three times to
indicate the manual feed slot is ready.
When loading an envelope, or a sheet of thick paper, push the media into the manual feed slot until you feel
the paper feed rollers pull it.
6. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
• If the document does not fit on one sheet, both the Power LED and the Warning LED light up. Place
another sheet of paper in the manual feed slot, and then press Mono Start or Colour Start.
• Make sure printing has finished before you close the manual feed slot cover.
• When paper is placed in the manual feed slot, the machine always prints from the manual feed slot.
• The machine will eject paper loaded in the manual feed slot if a test page or report is printing.
• The machine will eject paper loaded in the manual feed slot during the machine's cleaning process.
Wait until the machine finishes its cleaning, and then load paper in the manual feed slot.
Related Information
• Load Paper
Related Topics:
• Choose the Right Print Media
• Error and Maintenance LED Indications
30
To Next Page
Loading...
