Brother DCP-T520W - Step by Step Guide for Creating and Installing a Certificate

Home > Network > Network Features > Reset the Network Settings to Factory Default
Reset the Network Settings to Factory Default
You can use your machine's control panel to reset the print server to its default factory settings. This resets all
information, such as the password and IP address.
• This feature restores all wired (supported models only) and wireless network settings to the factory
settings.
• You can also reset the print server to its factory settings using Web Based Management.
>> DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
>> MFC-T920DW/MFC-T925DW
DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
1. Press Menu.
2. Press a or b to select the following:
a. Select [Initial Setup]. Press OK.
b. Select [Reset]. Press OK.
c. Select [Network Reset]. Press OK.
3. Press a for [Reset] to confirm.
4. Press a for [Yes] to reboot the machine.
The machine restarts.
MFC-T920DW/MFC-T925DW
1. Press Settings.
2. Press a or b to make your selections:
a. Select [Network]. Press OK.
b. Select [Network Reset]. Press OK.
3. Press c for two seconds to confirm.
The machine restarts.
Related Information
• Network Features
Related Topics:
• Transfer Your Faxes or Fax Journal Report
266