Brother DCP-T700W - Check the Print Quality; Set the Date and Time

5
e Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
f Gently adjust the paper width guides to the
paper with both hands. Make sure that the
paper width guides touch the edges of the
paper.
g Close the output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support until it clicks, and then unfold
the paper support flap.
7
Check the print quality
a When the preparation process has finished, the
LCD shows this message
Set Paper and
q
Press Start
Press Colour Start.
b Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c If all lines are clear and visible, press a (Yes) to
finish the quality check and go to the next step.
If lines are missing, press b (No) and follow the
steps on the LCD.
8
Set the date and time
Setting the date and time allows the machine to clean
the print head regularly and maintain optimum print
quality.
a When the LCD shows this message, press OK.
Date&Time
q
Enter & OK Key
b Press a or b to enter the last two digits of the
year, and then press OK.
c Repeat for the Month and Day, and then Hours
and Minutes in 24-hour format.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
NOTE
You can change the date and time if needed. For
more information uuBasic User’s Guide: Setting
the date and time