Brother GT-341 - Lowering the Platen Height

GT-3 Series
4. Printing Directly from Applications
91
4-4-3. Lowering the Platen height
The Platen height can be lowered by 13 mm by replacing the Bush Platen Shaft and the Platen Positioning Plate
to "Platen Lowering Set" (option). Prepare a hexagon wrench (3 mm).
The adjustable height of the Platen (from the left most position "A" of the original to the bottom)
Original parts: 1 - 12 mm
Platen Lowering Set (option): 13 - 25 mm
0053Y
(1) Remove the Platen Fixing Lever and uninstall the Platen by lifting it up straight.
(2) Loosen the two hexagon head screws that fix Bush Platen Shaft.
Platen
Positioning Plate
Platen Lowering
Set
Hexagon head screws