GT-3 Series
(15) Lean the Print Head backward to the inside of the Carriage (left), hold the Knob and pull up the Print Head
and remove it from the printer (right). Keep the surface of the Print Head (Nozzles) safe, do not touch to other
parts or the Print Head may be seriously damaged.
(16) Mount the new Print Head on the printer. Fit the V-shaped groove to the Positioning Pin (right).
(17) Hold the knob of the Print Head (left) and push it downward so that the V-shaped groove can fit the
Positioning Pin. Push down the Print Head to fix the corner of the Print Head by the Flat Spring (right).
Surface of Print Head (Nozzles)
Positioning Pin
Slide the Print Head into the Flat
Spring from the right to the left.
To Next Page
Loading...
