4. Basic Printing Procedure
GT-541
34
4. Basic Printing Procedure
WARNING
If a foreign object gets inside the printer, immediately turn off the power switch and
disconnect the power cord, and contact the place of purchase or a qualified technician.
If you continue to use the printer while there is a foreign object inside, it may result in fire or
electric shocks or problems with correct operation.
Do not allow water or oil to get onto the printer, otherwise it may cause fire or electric shocks
or problems with correct operation.
If any liquids get onto the printer, immediately turn off the power switch and disconnect the
power cord, and contact the place of purchase or a qualified technician.
Do not use the printer if a problem is noticed such as smoke or a bad odor coming from the
printer, otherwise it may cause fire or electric shocks or problems with correct operation.
Immediately turn off the power switch and disconnect the power cord, and contact the place
of purchase or a qualified technician.
(The printer must never be repaired by the customer, as it can be extremely dangerous to
do so.)
CAUTION
This printer should only be used by operators who have received the necessary training in
safe use beforehand.
Leave sufficient space at the front of the printer, and avoid placing items in front of it,
otherwise the platen may hit them and be damaged, and if your hands get caught between
the platen and the object, injury may result.
Release your hand from the platen while the printer is operating. If your hand gets caught
between the platen or the T-shirt tray and the covers, injury may result.
Do not put your hands inside the covers while the printer’s power is turned on, otherwise
your hands may touch against moving parts and this may result in injury.
If a problem occurs with the operation of the printer, contact the place of purchase or a
qualified technician.
To Next Page
Loading...
