4. Printing Directly from Applications
GT-541
54
4-6-2. Printing More than One Print Using the Same Print Data
After making one print following the procedure in “4-6-1. Making One Print”, you can continue
making more prints using the same print data.
(1) If you change the printed material, we recommend setting the necessary print condition (see “4-3.
Setting the Printer Driver Condition”) and the Platen height before you print.
(2) Press the Print Button to start printing. The counter indicates how many images are printed.
4-7. Removing the T-shirt From the Platen
(1) Hold the shirt slightly to allow are to get between the shirt and the platen.
(2) Hold both shoulders of the T-shirt, and then pull it out straight from the Platen.
<Note>
Be careful not to get "wet" ink on your hands or printed material. Wash your hands or clothes with soap
if stained.
4-8. Fixing the Ink onto the T-shirt
To Fix the ink onto the T-shirt, A Heat Press is recommended.
Follow the instruction manual that comes with your Heat Press.
<Note>
An appropriate heat treatment requires 356 °F (180 °C) of heat for 35 seconds.
The fixing is important and if not done correctly the image may fade or have other symptoms.
The hat press should be used in a well ventilated environment.
After using the Heat Press, always confirm if the ink is completely dry and cured.
Make sure the surface of the Heat Press is clean before and after fixing the t shirt.
To Next Page
Loading...
