Brother GT-541 - Page 76

6. Maintenance
GT-541
66
(13) Use the one side of wet Clean Applicator to clean the front side of the Wiper Blade.
(14) Use the other side of the wet Clean Applicator to clean the rear of the Wiper Blade.
(15) Wet other two Clean Applicators and use them to remove ink or dust from the Print Head Caps.
Use one side of the Clean Applicator to clean one Print Head Cap.
<Note>
Do not use dry Clean Applicator; it cannot clean ink or dust. It may damage the Print Head Caps.
Wipe off the dirty ink of Clean Applicator with soft cloth if it is too dirty and wet with Wash Liquid.