8
Setting Up Your Printer
Do NOT connect the interface cable.
You will be prompted to connect the
interface cable during the driver
installation.
1 Open the front cover of the printer.
2 Unpack the drum unit assembly.
3 Rock it from side to side several times to
distribute the toner evenly inside the
assembly.
4 Put the drum unit assembly into the printer.
5 Close the front cover of the printer.
1 Pull the paper tray completely out of the
printer.
2 While pressing the paper guide release lever,
slide the adjusters to fit the paper size.
Check that the guides are firmly in the slots.
3 Fan the stack of paper well to avoid paper
jams and misfeeds.
4 Put paper in the paper tray.
Check that the paper is flat in the tray and
below the maximum paper mark.
5 Put the paper tray firmly back in the printer.
1 Make sure that the printer power switch is
off.
Connect the AC power cord to the printer.
2 Plug the AC power cord into an AC outlet.
Turn the power switch on.
3 After the printer has finished warming up,
the Ready LED stops blinking and stays
green.
4 Press the Go button. The printer prints a
test page.
Check that the test page has printed
correctly.
2
Install the Drum Unit
Assembly
3
Load Paper in the Paper
Tray
4 Print a Test Page
Paper guide release lever
Up to here.
Unfold the Support flap.
Step 1
To Next Page
Loading...
