Brother HL-2070N - For Windows NT 4.0 Users; Installing the TCP;IP Protocol; Installing the Brother Peer-To-Peer Software

Network printing from Windows
®
: basic TCP/IP Peer-to-Peer printing
3 - 3
3
4 Select the port that you wish to use. Typically this would be Standard TCP/IP Port. Then click the New
Port... button.
5 The Standard TCP/IP Port Wizard will start. Follow steps 8 to 12 of Printer driver not yet installed on
page 3-1.
For Windows NT
®
4.0 users
Windows NT
®
4.0 users can send print job using Brother Peer-to-Peer Print software provided on the Brother
CD-ROM supplied with the printer.
Installing the TCP/IP protocol
If you did not install the TCP/IP protocol during the installation of your Windows NT
®
4.0 system (either
workstation or server) follow these steps. If you have already installed the TCP/IP protocol, proceed to the
next section, Installing the Brother Peer-to-Peer software on page 3-3.
1 Go to the Start button, select Settings, and then Control Panel.
2 Run the Network applet by double clicking the Network icon and then click the Protocols tab.
3 Select Add, and double click the TCP/IP Protocol.
4 Ins ert the requested disk(s), or CD-ROM, to copy the required files.
5 Click the Close button. The Windows NT
®
4.0 system will review protocol bindings and then you will see
the TCP/IP Properties dialog.
6 Configure the host IP address, subnet mask, and gateway address in that dialog. Consult your system
manager for these addresses.
7 Click OK to exit (your Windows NT
®
4.0 workstation or server will need to be re-booted).
Installing the Brother Peer-to-Peer software
1 Start the CD-ROM installation menu program according to the printer Quick Setup Guide.
2 Select the HL-2070N and the desired language. Then click Install Other Drivers or Utilities.
3 Select the Network Print Software installation program.
4 Click Next in response to the Welcome message.
5 Read the license agreement carefully. Then follow the on-screen instructions.