App. 3-1
Confidential
APPENDIX 3 INSTALLING THE MAINTENANCE PRINTER DRIVER
To identify terminals connected via USB interface, the PC requires the corresponding
virtual USB devices to be implemented by driver. If you connect any number of the printer
to your PC, therefore, the same number of virtual USB devices will be automatically
configured on your PC. To prevent virtual USB devices from being configured limitlessly,
use the unique driver installation procedure described below that enables your PC to
identify terminals via single virtual USB device.
(1) Check that the power switch of the printer is turned off. Disconnect the USB cable that
connects the printer with PC.
(2) Turn on your PC.
(3) Open the front cover, and turn the power supply of the printer on while holding down
the [Go] button. Make sure that the Toner/Drum/Error LED lights up.
(4) Release the [Go] button, and then make sure that all LEDs are off.
(5) Press the [Go] button for the 2 seconds, and the Error LED lights up.
(6) Click the “maintenance.exe” of the Printer Maintenance Driver which has been copied
in the “hl2200” folder to start.
(7) The following screen appears, indicating the detection of device installation wizard.
Click Next to proceed.
To Next Page
Loading...
