Setting Up the Machine
12
3 Printing a test page
Improper Setup
DO NOT connect the interface cable yet.
1 Make sure that the printer power switch is off.
Connect the AC power cord to the printer.
2 Plug the AC power cord into an AC power
outlet. Turn on the printer power switch.
3 Unfold support flap 1.
4 After the printer has finished warming up, the
Ready LED / Go button (1) stops blinking and
stays blue.
5 Press the Go button. The printer prints a test
page. Check that the test page has printed
correctly.
Note
This function will not be available after the first
print job you send from your computer.
1
To Next Page
Loading...
