Configuring your machine for a wireless network (For HL-2270DW)
16
3
How to configure your wireless machine, using the one-push wireless setting mode 3
a Make sure that the power cord is plugged in.
b Turn on the machine and wait until the machine is in the Ready state.
c Press the wireless setup button located at the back of the machine for less than 2 seconds as shown in
the illustration below. This will put the machine in one-push wireless setting mode. This feature will
automatically detect which mode your WLAN access point/router uses for one-push configuration (Wi-Fi
Protected Setup or AOSS™).
• Use a pointy object such as a ballpoint pen to press the button.
• If you press the button for 3 seconds or more, the machine will change to the PIN Method of the Wi-Fi
Protected Setup mode. See Using the PIN Method of Wi-Fi Protected Setup on page 18.
d The machine starts the one-push wireless setting mode.
The machine will search for an WLAN access point/router that supports Wi-Fi Protected Setup or
AOSS™ for 2 minutes.
e Put your WLAN access point/router in the Wi-Fi Protected Setup mode or AOSS™, depending on what
is supported by your WLAN access point/router. Please refer to the instruction manual supplied with your
WLAN access point/router.
To Next Page
Loading...
