19
Windows
®
Wireless Network
Wireless Network
Windows
®
Macintosh
h Choose Temporarily use a USB cable
(Recommended) and then click Next.
i Temporarily connect the USB cable (not
included) directly to the computer and the
machine.
Go to Step n.
j Choose Temporarily use an Ethernet (LAN)
cable and then click Next.
k Remove the protective cap from the LAN
connector.
l Temporarily connect the Brother wireless
device to your access point using a network
cable (not included) and click Next.
m Choose the machine you wish to configure,
and click Next. If the list is blank, check if the
access point and the machine are powered on,
and then click Refresh.
The default Node name is "BRNxxxxxxxxxxxx".
To Next Page
Loading...
