Brother HL-4050CDN - Page 232

Confidential
3-124
(3) Remove the Screw pan (S/P washer) M4x8, and then remove the Ground terminal.
(4) Remove the two Taptite, flat B M3x10, and then remove the Power inlet socket from the
Frame unit.
Fig. 3-184
(5) Remove the three bind B M4x12 Taptite screws, and then release the Hook to remove the
PS PCB unit from the Frame unit.
Fig. 3-185
Frame unit
Ground terminal
Power inlet
socket
Taptite, flat B M3x10
Screw pan
(S/P washer) M4x8
PS PCB unit
Taptite, bind B M4x12
Frame unit
Hook
<Back side>
<Right side>