Wireless configuration for Macintosh
®
using the Brother automatic installer application
78
5
m To communicate with the un-configured wireless printer, temporarily change the wireless settings on
your computer to match printer’s default settings shown on this screen. Check the box after you confirm
these settings, and then click Next.
Note
You can temporarily change the wireless settings on your computer, following the steps below:
1 Click the AirPort status icon and select Open Internet Connect....
2 Click the Network tab to see the available wireless devices. You can see the Brother wireless print
server in the Network option. Select SETUP.
3 Your wireless network is connected successfully.
n Choose the printer you wish to configure, and click Next. If the list is blank, check if the access point and
the printer are powered on, and then click Refresh.
Note
The default Node name is “BRNxxxxxx” for the users that temporarily connect with a network cable, or
“BRWxxxxxx” for the users that connect without a network cable (where “xxxxxx” are the last six digits of
Ethernet address).
To Next Page
Loading...
