Wireless configuration for Macintosh
®
using the Brother automatic installer application
86
5
j You need to temporarily change your computer’s wireless settings. Follow the on-screen instructions.
Make sure you take notes on all the settings such as SSID or channel of your computer. You will need
them to return your computer back to its original wireless settings, and then click Next.
k To communicate with the un-configured wireless printer, temporarily change the wireless settings on
your computer to match printer’s default settings shown on this screen. Check the box after these
settings, and then click Next.
Note
You can temporarily change the wireless settings on your computer, following the steps below:
1 Click the AirPort status icon and select Open Internet Connect....
Item Record the current wireless computer settings
Communication mode: (Infrastructure / Ad-hoc)
Channel: (1-14)
Network name: (SSID / ESSID)
Authentication method: (Open system / Shared key /
WPA/WPA2-PSK / LEAP)
Encryption: (None / WEP / WPA / TKIP / AES/ CKIP)
Encryption key:
To Next Page
Loading...
