Installing the Printer Driver
26
STEP 2
Windows
®
Wireless
Network
Windows
®
Installation using a wireless computer
Improper Setup
If you have previously configured the wireless
settings of the printer, you must reset the
NETWORK menu settings before you can
configure the wireless settings again.
1 Press the + or - button to choose
NETWORK. Press Set.
2 Press the + or - button to choose
FACTORY RESET. Press Set.
3 Press Set again.
1 Make sure that the printer power switch is on.
2 Click Install Printer Driver on the menu
screen.
3 Click Wireless Network users.
4 Choose Wireless Setup and Driver Install,
and then click Next.
5 Choose Automatic (Recommended) and
then click Next.
6 Choose I’m not able to connect my device to
my access point with a network cable and
then click Next.
7 If you have choosen This PC has wireless
capability, check I am using an access point
in infrastructure mode, and then click Next.
If you choose This PC uses a network cable
to connect to the wireless network, you must
configure the wireless settings from the control
panel. Click Next and follow the on-screen
instructions to complete the setup. (See
Chapter 3 in the Network User’s Guide on the
CD-ROM.) When finished, go to the driver
installation in step 16 on page 29.
To Next Page
Loading...
