Setting Up the Machine
12
STEP 1
4 Print a test page
Improper Setup
DO NOT connect the interface cable yet.
1 Make sure that the printer power switch is off.
Connect the AC power cord to the printer.
2 Plug the AC power cord into an AC power
outlet. Turn on the printer power switch.
3 After the printer has finished warming up, the
LCD shows READY.
4 Press Go. The printer prints a test page. Check
that the test page has printed correctly.
Note
This function will not be available after the first
print job you send from your PC.
5 Setting your language on the
control panel
1 Press the + button until the LCD shows SETUP.
Press Set.
SETUP
2 Press Set again.
LANGUAGE
3 Press the + or – button to choose your
language. Press Set to accept.
=ENGLISH
Now go to
Go to the next page to install the driver.
To Next Page
Loading...
