Introduction
2
1
Configuration using Web Based Management (web browser) 1
Use the IPsec setting screen for Web Based Management to specify the IPsec connection conditions.
The IPsec connection conditions are comprised of three Template types: Address, Service, and IPsec, and
a maximum of 10 connection conditions can be configured.
a Start your web browser.
b Type “http://machine’s IP address/” into your browser (where “machine’s IP address” is the machine’s IP
address).
For example:
http://192.168.1.2/
c No password is required by default. Enter a password if you have set one and press .
d Click the Network tab.
e Click Security.
f Click IPsec.
g You can configure the IPsec settings from the screen below.
Status
Select Enabled or Disabled for IPsec.
Negotiation Mode
Select the mode for IKE Phase 1.
To Next Page
Loading...
