Brother MFC-240C - Print Quality Check; Choosing Your Language

Setting Up the Machine
10
STEP1
7 Print quality check
1 After the cleaning cycle is finished, the LCD
shows:
Set Paper and
q
Press Start
2 Make sure paper is loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3 Check the quality of the four colour blocks on
the sheet.
(black/yellow/cyan/magenta)
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
4 The LCD shows:
Is Quality OK?
q
1.Yes 2.No
5 Do one of the following:
 If all lines are clear and visible, press 1
(Yes) on the dial pad to finish the quality
check.
 If you can see missing short lines, press 2
(No) on the dial pad and go to step 6.
6 The LCD asks you if the print quality is OK for
black and colour. Press 1 (Yes) or 2 (No) on the
dial pad.
Black OK?
q
1.Yes 2.No
Color OK?
q
1.Yes 2.No
After pressing 1 (Yes) or 2 (No) for both black
and colour, the LCD shows:
Start Cleaning?
q
1.Yes 2.No
7 Press 1 (Yes), the machine will then start
cleaning the colours.
8 After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
8 Choosing your language
You can change the LCD language.
1 Press Menu, 0, 0.
2 Press a or b to choose your language
(English or Spanish).
Press OK.
3 Press Stop/Exit.
OK Poor