Installing the Driver & Software
18
STEP 2
Macintosh
®
Macintosh
®
USB
2
For USB Interface Users
(For Mac OS
®
X 10.2.4 or greater)
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 13.
Note
For Mac OS
®
X 10.2.0 to 10.2.3 users, upgrade to
Mac OS
®
X 10.2.4 or greater. (For the latest
information for Mac OS
®
X, visit
http://solutions.brother.com
)
1 Insert the USB cable into the USB port marked
with a symbol. You will find the USB port
next to the handset cord port as shown below.
2 Connect the USB cable to your computer.
Improper Setup
DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
3 Turn on the machine by connecting the power
cord.
4 Turn on your Macintosh
®
.
5 Put the supplied CD-ROM into your CD-ROM
drive.
6 Double-click the Start Here OSX icon to install.
Follow the on-screen instructions.
Note
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.
7 The Brother software will search for the Brother
device. During this time the following screen
will appear.
8 When this screen appears, click OK.
For Mac OS
®
X 10.3.x or greater users:
The MFL-Pro Suite, Brother printer driver,
scanner driver and Brother
ControlCenter2 have been installed and
the installation is now complete.
Go to step 13.
9 For Mac OS
®
X 10.2.4 to 10.2.8 users:
Click Add.
To Next Page
Loading...
Need help?
General
