Troubleshooting and routine maintenance
165
C
f Turn the drum unit gear by hand while
looking at the surface of the OPC
drum (1).
g When you have found the mark on the
drum that matches the print sample,
wipe the surface of the OPC drum with a
dry cotton swab until the dust or glue on
the surface comes off.
DO NOT clean the surface of the
photosensitive drum with a sharp object.
h Put the toner cartridge back firmly into
the drum unit until you hear it lock into
place.
Make sure that you put in the toner
cartridge properly or it may separate from
the drum unit.
h
To Next Page
Loading...
