32
For Wireless Network Users
e Choose Yes, I have a USB cable to use for
installation. and then click Next.
f Temporarily connect the USB cable directly to
the computer and the machine.
If the confirmation screen appears, check the
box and click Next, go to g.
Otherwise, go to h.
g When the following screen appears, check Yes
if you want to connect to the listed SSID. Click
Next and go to j.
h When the following screen appears, the wizard
will search for wireless networks available to
your machine. Choose the SSID that you wrote
down for your network in step 19-a on
page 29, and then click Next.
• For instructions on connecting the USB cable
to the USB port of your machine, see Connect
the USB cable on page 15.
• If this screen appears, read the Important
Notice. Check the box after you confirm the
SSID and Network Key, and then click Next.
• If a list of SSIDs is not displayed, make sure
your access point is on and set to broadcast the
SSID. Make sure the machine and the access
point are within communication range, then
click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.
To Next Page
Loading...
Need help?
General
