Brother MFC-J2310

33
For Wireless Network Users
Wireless Network
i Enter the Network Key you wrote down in
step 19-a on page 29, and then click Next.
j Click Next. The settings will be sent to your
machine.
k Disconnect the USB cable between the
computer and the machine.
l Click Next to continue to install MFL-Pro Suite.
Wireless setup is now complete. The
Wi-Fi button at the upper right of the
Touchscreen changes to a four-level
indicator that displays the wireless signal
strength of your access point/router.
The Wi-Fi LED on the control panel
lights up, indicating that the machine’s
Network I/F is set to WLAN.
To install MFL-Pro Suite
For Windows
®
users:
Now go to
Step 22-e on page 39
For Macintosh users:
Now go to
Step 22-d on page 41
NOTE
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to j.
NOTE
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.