2
2
Load plain Letter/A4
paper
DO NOT carry the machine by holding the scanner
cover, the Jam Clear Cover, the manual feed slot
cover, or the control panel. Doing this may cause
the machine to slip out of your hands. Carry the
machine by sliding your hands into the handhold
indentations located on each side of the machine.
For detailed information, see the Product Safety
Guide.
a Pull the paper tray (for MFC-J4610DW, paper
tray #1, the upper tray) a, completely out of
the machine.
b Open the output paper tray cover a.
c Gently press and slide the paper guides a to fit
the paper size. Make sure that the triangular
mark b on the paper guide a lines up with the
mark for the paper size you are using.
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray (for
MFC-J4610DW, tray #1) print side down and
top edge first.
1
1
Always make sure that the paper is not curled or
wrinkled.
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
1
2
To Next Page
Loading...
Need help?
General
