45
For Network Users
Reset the network settings to factory default
To restore all network settings of the internal Print/Scan server to the factory default, please follow the steps below.
a Make sure the machine is idle, then disconnect all cables from the machine (except the power cord).
b Press Settings.
c Press s or t to display Network, and then press Network.
d Press s or t to display Network Reset, and then press Network Reset.
e Press Yes.
f Hold down Yes for 2 seconds to confirm.
g The machine will restart, re-connect the cables once this is complete.
Entering Text for Wireless Settings
Up to four letters are assigned to each letter button on the Touchscreen. By pressing the correct button repeatedly,
you can access the character you want.
Press to cycle between letters, numbers and special characters. (The characters available may differ
depending on your country.)
Inserting spaces
To enter a space, press then press the space button or .
Repeating characters
If you need to enter a character that is on the same button as the character before, press c to move the cursor to
the right.
Making corrections
If you entered a character incorrectly and want to change it, press to delete it and re-enter the correct
character.
To Next Page
Loading...
Need help?
General
