37
To turn the Length function on or off:
1 While holding down c, press T once, and keep c held down to display the
current length of the label (the text and both margins). Then the display will show the cur-
rent label length setting (ON or OFF).
2 While still holding down c, continue pressing T until the desired label length set-
ting is displayed.
☞ The Length indicator comes on when ON is selected.
3 Release c. If ON was selected, the current label length setting is displayed.
4 Press h or e to select the desired length or use the number keys to enter a length.
☞ To change the units (inches or centimeters) used to display the label length, press
M until the desired units are displayed.
To change the length in 1” (1.0-cm) steps, hold down either h or e, and then
release the key when the desired setting is displayed.
5 Press r.
EXAMPLE
To select a label length of 5”:
1
While holding down c, press T once, and keep c held down.
2 While still holding down c, continue press-
ing T until ON is displayed.
3 Release c.
5.3inch
LENGTH
OFF
LENGTH
To Next Page
Loading...
