86
To change the barcode parameter settings:
3 Press .
☞
To return to the barcode data without changing any parameter settings, press .
4 Press or until the parameter that you wish to change appears.
5 Press or until the desired setting is displayed.
6 Repeat steps 4 and 5 until all parameters are set as you wish.
7 Press .
To add a special character to the barcode data:
8 Press or until the cursor is below the character immediately to the right of
where you wish to add the special character.
9 Hold down and press .
0 Press or until the desired special character is displayed.
☞
The following special characters can only be entered when using types CODE 39
or CODABAR.
The following special characters can only be entered when using types EAN 128 or
CODE 128.
SYMBOL
SPECIAL
CHARACTER
1+
2$
VALUE
SPECIAL
CHARACTER
VALUE
SPECIAL
CHARACTER
VALUE
SPECIAL
CHARACTER
3 # 69 ENQ 87 ETB
4 $ 70 ACK 88 CAN
11 + 71 BEL 89 EM
28 < 72 BS 90 SUB
29 = 73 HT 91 ESC
30>74LF91{
32 @ 75VT92FS
Home
Clear
✕
Home
End
New Block
Code
Symbol
Shift
Home
End