Brother P-touch D450 - Turning Power On;Off; Feeding Tape; Setting LCD Display Options

11
Turning Power On/Off
GETTING STARTED
Turning Power On/Off
Press ( ) to turn the P-touch on.
Press ( ) again to turn the P-touch off.
NOTE
Your P-touch has a power saving function that automatically turns itself
off if no key is pressed within a certain time under certain operating
conditions. Refer to “Specifications” on page 52.
Feeding Tape
To feed the tape, press the following keys:
Setting LCD Display
 LCD Contrast
The default setting is [0].
 Back Light
The default setting is [ 開 ].
NOTE
• You can also set the back light setting by pressing ( ).
• Power can be saved when the back light is turned off.
• The back light is turned off automatically if there is no operation. It
can be turned back on by pressing any key. The back light turns off
when printing.
() + ().
()  / [設定 ]  ( ) or ( )  / [調整 ]  () or
()
 / [畫面對比度 ]  () or ( )  /
[-2 - +2]
 ( ) or ( ).
()  / [設定 ]  () or ( )  / [背光 ]  () or
()
 / [開 / 關 ]  ( ) or ( ).