Brother P-touch D450 - Adjusting the Label Length; Printing from Label Collection

41
Adjusting the Label Length
LABEL PRINTING
Adjusting the Label Length
When the tape cassette comes to the end, the printed length may be less
accurate.
In this case, you can adjust the label length.
NOTE
Adjusting Label Length by 1 level increases total label length by
approximately 1%.
Printing from the Label Collection
 Printing a label from the label collection stored in the P-touch
NOTE
Only 12 or 18 mm tape can be used for Label Collection.
()  / [設定 ] () or ( )  / [調整 ]  () or
()
 / [長度 ]  () or ( )  / [-5 - +5] 
() or ( ).
()  / [標籤集 ]  () or ( )  / Select a category
 () or ( )  / Select a label  () or ( ) 
Check the label image
 ()  / [列印 ]  ( ) or ( ) 
/ Select the number of copies
 ( ), ( ) or ( ).