What to do if my Brother P-touch Embellish display stays blank after turning it on?
If the display of your Brother Label Maker remains blank after you turn it on: * First, verify that the batteries are correctly inserted. * If they are, the batteries may be weak, so try replacing them. * Also, if you're using an AD-24ESA adapter, ensure it's properly connected.
Why does my Brother P-touch Embellish say 'Battery Empty!'?
The 'Battery Empty!' message on your Brother Label Maker means that the installed batteries are running low and need to be replaced to continue using the device.
Why does my Brother P-touch Embellish say 'Battery Low!'?
The 'Battery Low!' message on your Brother Label Maker indicates that the batteries are weak. If you are using AAA alkaline batteries, replace them with new ones. If you are using Ni-MH batteries, ensure they are fully charged.
What does 'No Cassette!' mean on my Brother Label Maker?
The 'No Cassette!' message on your Brother Label Maker indicates that there is no cassette installed in the machine.
Why does the setting clear on my Brother P-touch Embellish Label Maker by itself?
If the settings on your Brother Label Maker are clearing on their own, it could be due to weak batteries. Try replacing them. Also, if the power is disconnected for more than three minutes, all text and formats in the display settings will be cleared.
How to clear all text and format settings on my Brother P-touch Embellish?
To clear all text and format settings on your Brother Label Maker to create a new ribbon/tape: * Press + and select [Text&Format]. * Alternatively, press / [Clear] / [Text&Format].
What to do if the tape does not feed properly or gets stuck inside my Brother P-touch Embellish?
If the tape in your Brother Label Maker isn't feeding correctly or gets stuck, check that the end of the tape feeds under the tape guides. Also, make sure you are not touching the Cutter Lever during printing.
Why does the Brother Label Maker power off when I try to print?
If your Brother Label Maker turns off when you try to print, it could be due to the following reasons: * The batteries may be weak, so try replacing them. * Ensure that the batteries are correctly inserted. * You might be using the wrong AC Adapter. It is recommended to use the AD-24ESA Adapter.
Why does my Brother P-touch Embellish not print or the printed characters are not formed properly?
If your Brother Label Maker is not printing correctly, check the following: * Ensure that the cassette is correctly inserted. * If the cassette is empty, replace it with a new one. * Make sure the Tape Cassette Cover is closed correctly.
General| Type | Label Maker |
|---|---|
| Technology | Thermal Transfer |
| Print Resolution | 180 dpi |
| Print Speed | up to 20 mm/sec |
| Display | LCD |
| Keyboard | QWERTY |
| Connectivity | USB |
| Label Widths Supported | 12 mm |
| Max. Label Length | 1 m |
| Tape Type | TZe tape |
| Power Source | AC adapter or batteries |
| Model | Brother P-touch Embellish |
| Cutter | Auto and Manual |
Instructions on how to install power supply and tape or ribbon cassette.
Guidelines to avoid fire, burns, injury, electric shocks, and other hazards.
Advice to avoid personal injury, liquid leakage, burns, or heat.
Steps to turn on the machine and set initial language and measurement units.
Covers text input, switching case, and using the enter key for new lines.
How to preview print output and feed blank tape.
Steps for printing labels, including copy count and tape cutting.
Procedure to reset the printer to factory settings, clearing all data and configurations.
To Next Page