Printing Labels
X Text Preview
You can preview the text before printing.
The LCD displays the whole text and the label length
(inch/mm), then returns to the original text.
You can only preview the text. Style, size, underline,
frame, or any additional features cannot be previewed.
X Feeding (Tape Feed)
+
This function will feed approximately 25mm of blank tape.
X Printing
To prevent damage to the tape, do not touch the cutter
lever while the message Printing or Feeding is
displayed.
To cut off the label, push in the tape cutter lever on the
upper-left corner of the label maker.
Peel the printed label from the label backing and apply the
label.
X Printing multiple copies ( + )
You can print up to 9 copies of each label.
[Copies]
You can also select the number of copies by entering with
the Number Keys ~ .
X Removing the Label Backing
This label maker is equipped with a peeler that allows you
to remove the backing from labels.
1. Insert the label, with the printed surface facing down,
as far as possible into the built-in peeler.
2. Fold back the label to the right and quickly pull out the
label. The end of the backing is slightly separated
from the label.
3. Peel the printed label away from the label backing and
apply the printed label.
Saving Label Files
X Memory ( + )
You can save your original labels on to your label maker.
Up to 3 labels can be saved and recalled for printing at a
later time. You can also edit and overwrite the stored label.
[File]
To Save: [Save]
To Print: [Print]
To Open: [Open]
NOTE
If you try to store a label when there is already a label
stored to that number, a message Overwrite? appears.
Press to save your new label. Press to cancel.
Resetting the label maker
You can reset the label maker when you want to restore it
to factory settings, or in the event that the label maker is not
working correctly.
1 Press to turn off the power.
2 While holding down and , press
to turn on the power.
3 Release , and then release and .
The internal memory is reset, and all text, settings and
stored files are cleared.
1. Insert the label, with the printed surface facing down,as far as possible into the built-in peeler.
2. Fold back the label to the right and quickly pull out the labe l. The end of the backing is slightly separated from the labe l.
3. Peel the printed label awa y from the label backing and apply the printed label.
1 Press to turn off the power.
To Next Page
Loading...
Need help?
General
