Brother P-touch PT-P750W - I want to check that my network devices are working correctly.; I want to reset the P-touch labelers network settings.

Appendix
53
A
I want to check that my network devices are working correctly.
Question Solution
Is your P-touch labeler, access
point/router or network hub turned on?
Make sure you have confirmed all instructions in First check the following:
on page 51.
Where can I find the P-touch labeler
network settings, such as IP address?
Check [Communication settings] in the Printer Setting Tool.
See Using the Communication Settings on page 19 for details about
[Communication settings].
Is your P-touch labeler correctly
connected to the WLAN access
point/router?
Check if the Wi-Fi lamp or the NFC lamp is lit.
Others
Question Solution
I want to reset the P-touch labeler’s
network settings.
With the P-touch labeler off, press and hold the Feed & Cut button while
holding down the Power button. When the Editor Lite lamp starts flashing and
the Status lamp lights orange, press the Feed & Cut button twice while
continuing to hold down the Power button. The network settings will be reset
to the factory settings.
To turn off the APIPA setting and reset the network settings, press the
Feed & Cut button four times.