Brother P-touch QL-700 User Manual

[6] Disassembling the Upper Cover and the Under Cover ................................................III-16
[7] Removing the Mecha ASSY ........................................................................................III-19
[8] Removing the Cutter Unit ASSY.................................................................................III-20
[9] Disassembling the Mecha ASSY..................................................................................III-21
3.5 REASSEMBLING PROCEDURE.......................................................................................III-26
[1] Reassembling the Mecha ASSY...................................................................................III-26
[2] Installing the Cutter Unit ASSY...................................................................................III-32
[3] Reassembling the Panel Cover.....................................................................................III-33
[4] Installing the Mecha ASSY..........................................................................................III-35
[5] Reassembling the Upper Cover and the Under Cover..................................................III-37
[6] Installing the Panel Cover ............................................................................................III-41
[7] Installing the Media PCB ASSY..................................................................................III-42
[8] Reassembling the Sub ASSY Inlet...............................................................................III-43
[9] Installing the Main PCB ASSY and the Power supply ASSY.....................................III-45
[10] Installing the Top Cover ASSY and the Thermal Tape ...............................................III-50
[11] Demonstration Print and Final Check ..........................................................................III-53
CHAPTER IV TROUBLESHOOTING AND
ERROR MESSAGE...........................................IV-1
4.1 PRECAUTIONS.....................................................................................................................IV-1
4.2 AFTER REPAIRING .............................................................................................................IV-1
4.3 STATUS LED CONTROL IN DIFFERENT SITUATIONS AND
MEASURE AGAINST ERRORS..........................................................................................IV-2
4.4 ERROR MESSAGE ...............................................................................................................IV-4
4.5 TROUBLESHOOTING FLOWS...........................................................................................IV-7
[1] Printing is performed with specific dots omitted. ..........................................................IV-7
[2] The tape is not detected correctly...................................................................................IV-8
[3] LED does not turn on. ....................................................................................................IV-9
[4] No printing is performed..............................................................................................IV-10
[5] The interface malfunction.............................................................................................IV-10
[6] The tape is not cut.........................................................................................................IV-11
[7] The tape is not feed correctly. ......................................................................................IV-12
APPENDIX 1 SERVICEMAN SOFTWARE TOOL
(Version 1.00) ......................................................... 1-1
1.1 Role and Operating procedure of the VR Adjustment Tool.....................................................1-1
1.1.1 Role of the VR Adjustment Tool........................................................................................1-1
1.1.2 Operating procedure of the VR Adjustment Tool..............................................................1-1
1.2 Setting and Operating procedure of the Serviceman Software Tool........................................1-3
1.2.1 Role of the Serviceman Software Tool ..............................................................................1-3
1.2.2 Items Required for the Inspection ......................................................................................1-3
1.2.3 Setting of the Serviceman Software Tool...........................................................................1-3
1.3 Operating procedure of the Serviceman Software Tool ...........................................................1-4
1.3.1 Starting of the Serviceman Software Tool .........................................................................1-4
1.3.2 Performing of the Inspection..............................................................................................1-4
1.4 Inspection Details .....................................................................................................................1-6

Brother P-touch QL-700 Specifications

General

Print Technology	Direct Thermal
Maximum Tape Width	62 mm
Print Resolution	300 dpi
Connectivity	USB
Cutter	Automatic
Operating Systems Supported	Windows, Mac
Label Types	Die-cut labels, continuous tape
Compatible Label Width	62 mm
Power Source	AC adapter