How to fix the left side printout position if it is incorrect on my Brother TJ-4520TN?
If the left side printout position is incorrect on your Brother Printer, the label size may be set up incorrectly, so ensure you set the correct label size. Additionally, fine-tune the Shift X setting.
How to resolve incorrect printing position of small labels on Brother TJ-4520TN?
If the printing position of small labels is incorrect on your Brother Printer, the media sensor sensitivity may not be set correctly, so calibrate the sensor sensitivity again. Also, the label size may be incorrect, so set the correct label size and gap size. Finally, fine-tune the Shift Y setting. If using the BarTender software, set the Vertical Offset in the driver.
How to fix ribbon wrinkles on Brother Printer?
To address ribbon wrinkles on your Brother Printer, start by adjusting the Print Head tension using the Print Head Tension Adjustment Knob. If that doesn't resolve the issue, reinstall the ribbon and the label roll, ensuring they are correctly placed. Finally, adjust the print density/darkness to improve the print quality.
What does 'Take Label' mean on my Brother TJ-4520TN Printer and how to resolve it?
The 'Take Label' message on your Brother Printer indicates that Peeler Mode is enabled. To resolve this, remove the label.
What does 'Carriage Open' mean on my Brother TJ-4520TN Printer and how to fix it?
The 'Carriage Open' message on your Brother Printer means that the Print Head is open. To fix this, close the Print Head.
General| Print Technology | Thermal Transfer / Direct Thermal |
|---|---|
| Print Resolution | 300 dpi |
| Connectivity | USB, Serial, Ethernet, USB Host |
| Ribbon Core | 1 inch (25.4 mm) |
| Cutter | Optional |
| Peeler | Optional |
| Maximum Print Width | 4.09 inches (104 mm) |
| Memory | 256 MB RAM, 64 MB Flash |
| Media Type | Fanfold |
| Media Thickness | 0.0028 to 0.0079 inches (0.07 to 0.2 mm) |
| Ribbon Width | 4.33 inches (110 mm) |
| Operating Temperature | 41°F - 104°F (5°C - 40°C) |
To Next Page
