64 Icon System Manual T02985_02_03
MRI System Operation
5.1.2 Switching ON
The scanner must be in the “OFF” state is indicated by the lit red LED.
To start the scanner, press the power on button.
The system will automatically start.
During the green LED is flashing for about 40 seconds.
After startup the system is ready use, as indicated by the
lit green LED.
5.1.3 Switching OFF
The scanner must be in the “ON” state, indicated by the lit green
LED.
To power down, press the power off button. This will immediately
set the scanner into “OFF” state.
The “OFF” state is indicated by the lit red LED.
To Next Page
Loading...
