Need help?Do you have a question about the Bruker DektakXT and is the answer not in the manual?
General| Type | Surface Profiler |
|---|---|
| Technique | Contact Profilometry |
| Measurement Range (Horizontal) | Up to 55 mm |
| Vertical Measurement Range | Up to 1 mm |
| Vertical Resolution | 0.1 nm |
| Maximum Scan Length | 55 mm |
| Data Acquisition Rate | Up to 1000 Hz |
| Software | Vision64 |
| Z-Range | 1 mm |
| Scan Length | 50um - 55mm |
| Scan Speed | 0.01 mm/s to 10 mm/s |
| Stylus Force | 1 mg to 15 mg |
| Stylus Tip Radius | 2 μm |
| Stage | Motorized stage |
Standardized safety protocols for electrical and pneumatic systems during maintenance.
Step-by-step guide for starting the DektakXT system and software.
Procedure for safely shutting down the DektakXT system and associated components.
Instructions for placing and removing samples from the stage fixture.
Manual control for positioning the sample in the X and Y axes.
Manually adjusting the stage to ensure a level surface for measurements.
Utilizing motorized controls for precise sample positioning.
Interface for controlling motorized X-Y stage movement.
Interface for controlling motorized Theta stage movement.
Settings and calibration procedures for system hardware.
Configuring parameters such as scan type, range, and stylus force.
Step-by-step guide for performing a basic surface scan.
Procedures for launching and exiting the Vision64 software application.
To Next Page
