Basic Operations and Maintenance 3-1
3
BASIC OPERATIONS AND MAINTENANCE
This chapter describes the basic use of your DektakXT stylus surface profiler, including the software
procedures that involve profiler control. For instructions regarding other software procedures, see
Chapter 5 of this manual and the Vision64 online Help.
POWERING UP THE SYSTEM
The following steps include all possible startup contingencies. Normally you can simply press the
white O
N button on the EMO Box, turn on the computer and monitor, and then start the Vision64
software.
To power up the DektakXT system:
1 Verify that the cable from power supply adapter is connected to a wall outlet.
2 Verify that all USB cables are connected.
3 Verify that the software key is installed in a USB port of the computer (see Figure 3-1). (The software key is
shipped inside the Vision64 CD case.)
Figure 3-1: Software Key in a USB Port
4 Verify that the red Emergency Off button on the EMO Box is in the On (popped-up) position. If it is not,
release it by rotating it clockwise until it pops up (see Figure 3-2).
To Next Page
Loading...
Need help?
General
