Using Vision64 5-1
5
USING VISION64
This chapter explains basic Vision64 operations and describes the user interface. For full instructions
on using Vision64, see its online Help.
NOTE – For instructions on Vision64 software features that control the DektakXT profiler,
see Chapter 3.
OPENING VISION64
Select Start»Vision64 or double-click the Vision64 application button on the desktop or task
bar. The Vision64 Welcome screen appears, followed by the Vision64 Instrument tab, which includes
the DektakXT Live Video Display
.
Vision64 requires a software key to run (see Figure 5-1). If the key is not installed in a USB port, an
error message appears. If this occurs, install the key and restart Vision64.
Figure 5-1: Software Key in a USB Port
CLOSING VISION64
Click the Exit button in the upper right-hand corner. When you are prompted to confirm
that you want to exit the program, click Ye s.
Alternatively, you can close Vision64 by clicking the Vision64 application button on the
taskbar followed by Close Window.
To Next Page
Loading...
Need help?
General
