7. Check the electrode rods for water level measurement (Fig.
4.2.6/1) for dirt. If necessary, remove limescale and other
residues with a cloth or sponge.
Fig. 4.2.6: Electrode rods for water level measurement
Fig. 4.2.7: Inserting the evaporative filter disc and
water tank into the unit
8. Place the evaporation filter disc in the water tank (Fig. 4.2.7) and
fold the electrode rods down.
9. Insert the connecting shaft on the back of the filter retainer into
the gear motor receptacle in the unit.
10. The water tank can then be pushed in
so that
the front holder of
the filter retainer fits into the filter rack of the water tank.
11. Hook the outlet grille into the holder at the top of the unit (Fig.
4.2.8/1).
12. Close the outlet grille (Fig. 4.2.8/2). The magnets keep the
unit housing closed.
Fig. 4.2.8: Closing the outlet grille
To Next Page
Loading...
