5.
Menu overview
The following table gives an overview of the menu structure.
Coupling with the radio humidity
transmitter
By pressing the HUMIDITY +
or - button to select the desired radio coding,
see "Radio humidity transmitter coding"
on page 16.
Switching the signal tone on and off
By pressing the HUMIDITY button you can
choose between b1 and b0, see
"Activating/deactivating the signal tone"
on page 14.
Readjusting the humidity display
By pressing the HUMIDITY + or - key you
can select the desired value, see
"Readjusting the humidity-
display" on page 21.
Update rate of the internal humidity
sensor
By pressing the HUMIDITY + or - button, you
can select the desired value.
Number of days until the filter needs to
be changed.
After changing the filter, the display must be
changed in the menu by pressing the
HUMIDITY + or - button so that the error
message 03 disappears.
Number of days until the water needs
to be changed.
After the water change, the display must be
changed in the menu by pressing the
HUMIDITY + or - key to make the error
message 04 disappear.
Press the HUMIDITY + and - buttons
simultaneously to start a countdown to reset
the settings. ATTENTION: After the
countdown is completed, all settings of the
WLAN/WiFi module are deleted.
*Please note that the above mentioned intervals set by us ex works must be adjusted depending on the installation site and
duration of use. The intervals can be adjusted based on the conditions given on site in the menu ( see chapter "Select
menu" on page 16). If you have any questions, please contact our customer service ( "Customer service" on page 2).
Readjusting the humidity display
With this function you can set a correction value. To do this, select the item "OF" in the special menu using the standby key
. Use the HUMIDITY and keys to set the value (setting range: -9% ...+9% relative humidity). Once the setting has
been made, exit the menu by pressing the standby key .
To Next Page
Loading...
