EasyManua.ls Logo

Bryant 650A - Thermostats and System Controls; Thermostat Compatibility and Evolution Controls

Bryant 650A
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
—6—
THERMOSTATS AND ACCESSORIES
* Do not use in zoning heat pump applications.
This plate is designed to cover surrounding wall area located behind thermostat.
Thermostat conversion kit is a 24-vac accessory that can turn a 4-wire thermostat application into a 5-wire application. This kit can also be used
to replace a broken thermostat wire, or add an extra wire when needed.
** Outdoor air temperature sensor is an accessory for all Bryant electronic thermostats, except the non-programmable air conditioner version and
builder’s thermostats. It allows the temperature at a remote location (outdoors) to be displayed on the thermostat.
The outdoor air temperature sensor
must be
used with the dual fuel thermostat.
The outdoor air temperature sensor is included with the Thermidistat Control and dual fuel thermostat.
EVOLUTION™* CONTROLS
* When applied with Bryant’s Perfect Humidity™ series 355, 315 and FE4 Indoor Models.
Must be installed in Dual-Fuel Evolution system applications.
ACCESSORY USAGE GUIDELINE
*For tubing line sets between 50 and 175 ft and/or 20 ft elevation difference between indoor and outdoor units, refer to the Application Guideline
and Service Manual for Residential Split-System Air Conditioners and Heat Pumps using Puron Refrigerant.
Required for all applications.
Thermidistat™ Control—Non-Programmable/Programmable Thermostat with Humidity
Control (For use in Dual Fuel, AC, HP, and 2S applications. Includes Outdoor Air
Temperature Sensor.) TSTATBBPRH01-B*
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, Dual Fuel, Includes Outdoor
Sensor (TSTATXXSEN01-B) TSTATBBPDF01-B*
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, 2-Stage Heat/1-Stage Cool TSTATBBPHP01-B
Thermostat—Auto Changeover, Non-Programmable, °F/°C, 2-Stage Heat/1-Stage Cool TSTATBBNHP01-C
Standard Programmable Thermostat—Manual Changeover, 5-2 Day Programmable, °F/°C,
1-Stage Heat/1-Stage Cool TSTATBBSHP01
Builder’s Thermostat—Manual Changeover, Non-Programmable, °F/°C, 2-Stage Heat/
1-Stage Cool, Heat Pump TSTATBBBHP01*
Outdoor Air Temperature Sensor TSTATXXSEN01-B
Backplate for Non-Programmable Thermostat TSTATXXNBP01†
Backplate for Programmable Thermostat and Thermidistat™ Control TSTATXXPBP01†
Backplate for Builder’s Thermostat TSTATXXBBP01†
Backplate for Standard Programmable Thermostat TSTATXXSBP01
Thermostat Conversion Kit (4 to 5 Wire)—10 Pack TSTATXXCNV10‡
ACCESSORY DESCRIPTION
SYSTXBBUID01
Evolution™* ControlS Deluxe 7-Day Programmable (Wall-mounted system control.)
SYSTXBBUIZ01
Evolution Zone Control Deluxe Zoning 7-Day Programmable (Wall-mounted control for a multi-zone system.)
SYSTXBB4ZC01
Evolution 4-Zone Damper Control Module (Wall-mounted control for a four-zone system.)
SYSTXBBSMS01
Evolution Smart Sensor (Optional wall control used to monitor temperature and/or fan control in an
individual zone.)
SYSTXBBRRS01
Evolution Remote Room Sensor (Monitors temperature in an individual zone.)
SYSTXBBSAM01
Evolution System Access Module (Hardware for wireless access and control via phone or internet.)
SYSTXBBNIM01†
Evolution Network Interface Module (Connects Heat Recovery or Energy Recovery Ventilators or older two-
speed outdoor models to system.)
SYSTXXXBPU01
Back Plate for Evolution Control (Decorative wall plate.)
ACCESSORY
REQUIRED FOR LOW-AMBIENT
APPLICATIONS
(Below 55°F)
REQUIRED FOR LONG-LINE
APPLICATIONS*
(Over 50 Ft)
Crankcase Heater Yes Yes
Evaporator Freeze Thermostat Yes No
Compressor Start Assist—Capacitor and Relay Yes Yes
Puron Low-Ambient Pressure Switch Yes No
Wind Baffle
See Low-Ambient
Pressure Switch Instructions
No
Support Feet Recommended No
Puron Hard Shutoff TXV Yes† Yes†
Puron Liquid-Line Solenoid Valve for Heating No
See Long-Line
Application Guideline
This unit can be used as part of a Perfect Heat / Perfect Humidity System.
This system will remove more moisture per day than a standard system. A
Perfect Heat System will also average warmer air temperature in the heating
mode. A Perfect Heat/Perfect Humidity System requires the use of a Variable-
Speed Fan Coil with Thermidistat Control, Zone Perfect Plus, or Evolution
Control.
Z
O
N
I
N
G

Other manuals for Bryant 650A

Related product manuals