3
Key features
• Single cooling stage models are available from 3-5 tons.
• SEERs up to 14.1.
• EERs up to 12.0.
• Up to 28% lighter than similar industry units. Lighter rooftop units make for easier replacement jobs.
• Utility connections are the same because 3-5 ton units fit on existing Bryant rooftop curbs. This saves time and money on replace-
ment jobs.
• Standardized components and layout. Standardized components and controls make service and stocking parts easier.
• Scroll compressors on all units. This makes service, stocking parts, replacement, and troubleshooting easier.
• Field-convertible airflow. Being able to convert a unit from vertical airflow to horizontal makes it easy to overcome job site com-
plications.
• Standard Direct Drive - ECM indoor motor with optional belt drive system to meet nearly all applications.
• Provisions for bottom or side condensate drain.
• Capable of thru-the-base or thru-the-curb gas line routing.
• Single-point gas/electrical connection.
• Sloped, composite drain pan sheds water and won’t rust.
• Standardized controls and control box layout. Standardized components and controls make stocking parts and service easier.
• Tool-less filter access door.
• Clean, large, easy to use control box.
• Color-coded wiring.
• Large, laminated wiring and power wiring drawings are affixed to unit, making troubleshooting easy.
• Single, central terminal board for test and wiring connections.
• Fast-access, handled, panels for easy access on normally accessed service panels.
• “No-strip” screw system guides screws into the panel and captures them tightly without stripping the screw, the panel, or the unit.
• Mechanical cooling (115°F to 40°F or 46°C to 4°C) standard on all models. Winter Start Kit allows cooling operation down to
25°F (–4°C) and Motormaster
®
to –20°F (–29°C).
• High efficiency gas heat with induced-draft flue exhaust design.
• Induced draft motor ensures no flue gas can escape into the indoor air stream.
• Bryant-designed naturally draining heat exchanger, unlike positive pressure heat exchangers, do not need to be periodically, man-
ually drained. This saves labor and maintenance expense.
• 2-in. (51mm) disposable filters on all units.
• Refrigerant filter-drier on each circuit.
• Each circuit is protected with a high pressure and low pressure switch.
• Many factory-installed options ranging from air management economizers, 2 position dampers, plus convenience outlets, discon-
nect switches and smoke detectors.
• Standard (parts only) Warranty: 15 yr. Stainless steel, 10 yr. aluminized heat exchanger, 5 yr. compressor, 1 yr. parts.
• Factory-installed Perfect Humidity
™
dehumidification system on all sizes with round tube/plate fin condenser coils, includes
Motormaster
®
I controller.
FEATURES/BENEFITS
To Next Page
Loading...
Need help?
General
