To Next PageTo Next PageWhy does my Bryant T6?PRH?A Thermostat Control show '??' for the outdoor temperature?
If the Bryant Thermostat Control is unable to accurately measure the outdoor temperature, the display will show “??” in the section where the outdoor temperature is usually displayed.
What to do if my Bryant Thermostat Control cannot properly read humidity?
If your Bryant Thermostat Control is unable to properly read humidity, it is recommended to replace the Thermidistat Control.
How to troubleshoot a Bryant T6?PRH?A display module that doesn't power up?
If the Bryant Thermostat display module fails to power on after applying power, several checks are recommended. First, verify the presence of 24VAC at the Rc/Rh and C terminals. Next, check the voltage between Vg and V+. Also, ensure that the wiring polarity is correct. Finally, if a red pigtail is wired to Rc or Rh and a black pigtail to C, remove the two-wire pigtail and connect it to the V+ and Vg terminals.
General| Wi-Fi Connectivity | Yes |
|---|---|
| Display | Touchscreen |
| Geofencing | Yes |
| Remote Access | Yes |
| Energy Reports | Yes |
| Humidity Control | Yes |
| Filter Change Reminder | Yes |
| Category | Thermostat |
| Mobile App | Yes |
| Voice Control | Yes |
| Programmable | Yes |
| Power | 24 VAC |
Explains DANGER, WARNING, CAUTION, and NOTE signal words used with safety symbols.
Details features of programmable and non-programmable versions, including connectivity and memory.
Discusses power, wiring, model types, humidify connections, and sensor requirements.
Provides guidance on ideal and unsuitable locations for mounting the Thermidistat Control.
Step-by-step guide for installing the control in a two-piece configuration.
Step-by-step guide for installing the control in a single-piece configuration.
Illustrates connections between the Thermidistat Control, Fan Coil, and Heat Pump.
Lists summary of configuration options available for the Thermidistat Control.
Selects the type of HVAC equipment the Thermidistat Control will operate.
Configures the dry contact for specific functions like humidification or dehumidification.
Compensates for heat generated by electronics based on installation type.
Enables testing of heating, cooling, and fan operation without delays or setpoint adjustments.
Guides on setting mode, and default Energy Star schedules for programmable models.
Addresses display not powering up, voltage checks, and polarity issues.
Lists and explains error codes (E1, E3, E4, E5) and their meanings.
